R1 4.0T V16 Drag Racing Tuned 8000KV Motor ALL OUT BUILD w/ Double Ceramic Bearing 020115-1
This motor is fully built for drag racing, with all the upgrades listed below.
- Hand picked stator w/ resistance measurement
- Aligned sensor board
- Hand picked rotor w/ gauss measurement printout
- 6 pc titanium screw set for less magnetic drag and durability
-X5 Doubled Ceramic bearings installed (ceramic coated rings with steel balls) We changed this since we found that the X5 Double ceramic bearings perform better at higher rpms. We expect the X5 bearings to have slightly better durability with this higher rpm motor.
All this work is carefully done by our professional motor builder, with thousands of motor build experience.
***Note: If you are ordering outside of the U.S. or Canada we recommend purchasing our motors through your local hobby store.***
PROPRIETARY R1 STATOR LAMINATE MATERIAL
R1 V16 STATORS ARE DESIGNED USING COMPUTER SIMULATION TECHNOLOGY
EPOXY BONDED END WIND
ULTRA LOW RESISTANCE COLLECTOR RING
IMPROVED PUNCH & TOP END
LOW POWER LOAD, HIGH POWER OUTPUT
WARNING: This product can expose you to chemicals including lead and lead compounds, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
This product produces high amounts of energy and potentially very dangerous. Please read the manual and read the safety instructions before use.